Kenwood KVC-1000 instruction manual Connection of Antenna Unit, Booster switch

Connecting and Install Antenna Units

■Connection of Antenna Unit

2CAUTION

Incar antennas have a lower reception sensitivity than antennas intended for outside mounting. The picture may not appear or may be disturbed if the signal in your area is weak.

English

CAR DIVERSITY ANTENNA WITH BOOSTER CX-A330 OFF ON BOOST

		To the monitor unit
		Booster switch
ON	Set this booster switch to
	"OFF" if there is ghosting
	of the on-screen image
	due to electromagnetic
OFF	fields.

Ignition cable (Red)ª12V ACC

Fuse(1A)

Ground cable (Black) · (To car chassis)

■Installation for Antenna Unit

Ignition key switch

Car fuse box (Main fuse)

–+ Battery

•Attach the antenna to the inner glass surface of the rear window using double-sided tape. Carefully check the installation location as the tape can only be stuck on once.

•If the surface temperature of the glass of the rear window is low, warm it by turning on the power of the rear defogger. A cold window glass surface will weaken the adhesive strength of the double-sided tape.

Also, if installation inside the cabin is performed on a day with high humidity or when it is raining, the high humidity level will weaken the adhesive strength of the double-sided tape.

•Do not install the antenna in a location where it may obstruct the field of view during driving, such as on the windshield.

1Check the location where the antenna is to be attached. Clean off any grease or dirt from the installation location using the supplied glass cleaner, clean the area with water and allow to dry.

2CAUTION

Clean the glass thoroughly as failure to clean the glass can not only weaken the adhesive strength of the double-sided tape, but may also cause it to come loose.

2Remove the protective strips from the antenna parts and the back of the antenna unit.

3Attach the double-sided tape of the antenna parts and the antenna unit to the rear windshield glass. Attach the double-sided tape by firmly pressing down from the top. Secure cables using the supplied clampers.

4After attaching the antenna with the double-sided tape, allow it to sit undisturbed for 24 hours. Take care not to apply force to the antenna or allow it to get wet during this time.

5Wire the antenna cable to the hideaway unit.

Antenna parts

Antenna unit

Bundle cables
with the	Rear window
clamper bar

Accessory 8

Rear seat

33