INSTALLING/ REMOVING ALKALINE BATTERIES
◆Do not install batteries in a hazardous environment where sparks could cause an explosion.
◆Never discard batteries in fire; extremely high temperatures can cause batteries to explode.
◆Do not short circuit the battery case terminals.
◆Do not use rechargeable batteries.
Note:
◆If you do not plan to use the transceiver for a long period, remove the batteries from the battery case.
◆This battery case has been designed for transmitting at a power of approximately 1 W (the low power setting on your transceiver). If you want to transmit a stronger signal (using the high power setting on your transceiver), use an optional rechargeable battery pack.
1 To open the battery case, press on the two tabs on the upper rear of the case, then pull the two halvs apart.
2 Insert 6 AA (LR6) Alkaline batteries into the battery case.
ï Be sure to match the polarities with those marked in the bottom of the battery case.
3 Align the tabs of the cover with the base, then push down on the cover until it locks in place.
8