INSTALLING THE CAP OVER THE SPEAKER/ MICROPHONE JACKS
Install the cap over the speaker/ microphone jacks when not using an optional speaker/ microphone.
1Place the cap over the jacks so that the locking
tabs insert into the transceiver grooves.
2 While holding the cap in place, push it towards the bottom of the transceiver until the tabs on the cap click into place.
Note: To keep the transceiver water resistant, you must cover the speaker/ microphone jacks with the supplied cap.
ï To remove the cap, hold the top of the cap in place with your finger while inserting a 3 mm or smaller flat blade screwdriver under the bottom of the cap. Slowly slide the screwdriver in until its tip touches the tab inside the cap, then gently pry the cap up (handle of screwdriver moving away from the transceiver) to remove the cap.
INSTALLING THE (OPTIONAL) SPEAKER/ MICROPHONE
1 Insert the speaker/ microphone plugs into the speaker/ microphone jacks of the transceiver.
2 Place the locking bracket over the speaker/ microphone plugs so that the locking tabs insert into the transceiver grooves.
3While holding the locking bracket in place,
push it towards the bottom of the transceiver until the tabs on the bracket click into place.
Note:
◆When not using an optional speaker/ microphone, install the cap over the speaker/ microphone jacks.
◆ The transceiver is not fully water resistant when using a speaker/ microphone or headset.
ï To remove the locking bracket, push the bracket up from the base.
10