Kenwood TK-2170, TK-3170, TK-3173 ) A

INSTALLING THE (OPTIONAL) ANTENNA

Screw the antenna into the connector on the top of the transceiver by holding the antenna at its base and turning it clockwise until secure.

Note: The antenna is neither a handle, a key ring retainer, nor a speaker/ microphone attachment point. Using the antenna in these ways may damage the antenna and degrade your transceiverís performance.

INSTALLING THE BELT CLIP

Note: When first installing the belt clip, you must remove the battery pack from the rear of the transceiver.

1Remove the 2 screws from the rear of the transceiver, then remove the small, plastic black covering that was held in place.

2Insert the belt clip mount into the space on the rear of the transceiver.

3Using the 2 screws, affix the belt clip in place.

Note: Do not dispose of the plastic black covering! If you remove the belt clip, replace the covering into the space on the rear of the transceiver. Either this covering or the belt clip must be in place, otherwise the battery pack may not remain installed properly.