Parker Hannifin G2 manual Error number

Error number	45	- direction software over-travel
			Long:
			Soft_OT_-_direction
Error type:	[KIND_ERR] error		Short:
Measures:	[TYPE_E2] Stop deceleration.		-_Soft_OT
Main cause:	Attempted to move to outside of the - direction area via positioning move, but the command unit
	command value was outside of the - direction area.
Action to take:	Perform an error reset operation. If the command unit command value is outside of the area, move to
	the + direction. This error occurs only for the linear coordinates.
Error number	46	Emergency stop
			Long:
			EmergencyStop
Error type:	[KIND_RGR] Always error		Short:
Measures:	[TYPE_E2] Stop deceleration.		EMG_Stop
Main cause:	An emergency stop instruction was entered.
Action to take:	Reset the error.
Error number	49	Homing error
			Long:
			OriginError
Error type:	[KIND_ERRALM1] Error/operation alarm		Short:
Measures:	[TYPE_E2] Stop deceleration.		OriginErr
Main cause:	An error occurred during homing operation.
	[Subcode]
	1: Locating fixture position problem
Action to take:
Error number	50	Cannot execute
			Long:
			CantExec
Error type:	[KIND_ERRALM2] Error/operation alarm		Short:
Measures:	[TYPE_E2] Stop deceleration.		CantExec
Main cause:	Cannot execute.
	[Subcode]

1:Prohibited command

2:Execution in progress

3:Error status

4:Data is being used.

5:Invalid data

6:Access timing

7:Driver mode

8:Invalid program file

9:Nesting overflow

Action to take: