Parker Hannifin G2 manual Setting the Status to Servo ON, Basic Settings for Operating the Motor

4Basic Settings for Operating the Motor

4.5Setting the Status to Servo ON

The driver can be put into Servo On status through the following operation.

(1) Click the “I/O Config (I)” button in the “MainMenu” and then the “I/O config (L)” button.

Click the I/O Config (I)	Click the I/O Config
button.	(L) button.

(2) Enable Servo ON. Click the checkmark of “1” under DI and then click the Set (S) button.

Set Servo ON (DI-1) to “no check.” (Negative setting)

Set button

! Caution	Make sure to click the “Set” button after finishing the setting (the status will become
	Servo ON). Verify that the “S-RDY” LED on the front panel is turned on.

4-12