Parker Hannifin G2 manual Excessive position deviation error processing type

229 Excessive position deviation error processing type		While in machine setting mode
Minimum value:	0	Long:
Maximum value:	5	OverSpeedErrorType
Initial value:	1	Short:
Unit:	None	OVPeErrTyp

Specify the processing type when an excessive position deviation error occurs.

When operating the built-in controller axis:

0:Maintains the servo status after the axis operation stops (low level).

1:Turns the servo OFF after the axis operation stops (low level).

2:Stops the axis operation (low level) and turns the servo OFF immediately.

3:Maintains the servo status after the axis operation stops (high level).

4:Turns the servo OFF after the axis operation stops (high level).

5:Stops the axis operation (high level) and turns the servo OFF immediately. When performing the higher controller follow-up:

0:Switches to the built-in controller, and maintains the servo status after a deceleration stop.

1:Switches to the built-in controller, and turns the servo OFF after a deceleration stop.

2:Switches to the built-in controller, performs a deceleration stop, and turns the servo OFF immediately.

3:Switches to the built-in controller, and maintains the servo status after an immediate stop.

4:Switches to the built-in controller, and turns the servo OFF after an immediate stop.

5:Switches to the built-in controller, performs an immediate stop, and turns the servo OFF immediately.