Parker Hannifin G2 Operation mode number Unit None, Multi-channel communication status Unit None

347Operation mode number Unit: None

Indicates the operation mode number during or after operation.

348Multi-channel communication status Unit: None

Indicates that the multi-channel communication status has been set.

0:Single channel communication status

1:multi-channel communication status

349Multi-channel communication slave code Unit: None

Indicates the slave station (self-station) code in multi-channel communication.

354Maximum motor pulse velocity Unit: pulse/sec

Displays the maximum velocity defined for the motor/driver.

355Monitor resolution

Unit: pulse/rev, pulse/m

Displays the monitor resolution.

356Digital velocity sensitivity Unit: digit/rps, digit/mps

Displays the digital velocity sensitivity.

357 Maximum velocity

Unit: Axis command unit/sec

This parameter is defined by the smaller value of the maximum velocity [axis command unit/sec] set by the user and the maximum velocity [axis command unit/sec] converted from the maximum velocity [rps, mps] set by the motor and driver. The position command velocity is restricted by this value. In addition, for trapezoidal (constant acceleration/deceleration) move, the inclination of acceleration/deceleration is calculated from the acceleration/deceleration time parameter, feed velocity parameter in operation mode, and this parameter value.

358Z-phase signal pulse interval Unit: pulse/rev, pulse/m

Displays the Z-phase signal pulse interval.

360Load ratio Unit: x 1/100

Displays the load inertia/self-inertia and load mass/self-mass.