Parker Hannifin G2 manual Preoperation check

4.2Preoperation check

(1)Items to prepare

•Motor unit/driver/sensor/DC power supply

•PC utility (floppy disk)

•Level block for fixing the motor

•PC (with Windows 95/98/98SE/Me/NT4.0/2000 installed)

•Various cables

(2)Installation and Wiring

					Positioning
					controller
				PC utility (software)
	6) Sensor wiring		24V DC
			power supply
	(prepared bycustomers)
				(prepared by customers)
	Motor part			TB 2	PC
	(main body)
				CN 1	(prepared by customers)
		Sensor
				CN 4
	Level block			DrvGII	7) RS232C cable
				type
		4) Motor cable			(dedicated)
				driver	CP7576(77)S-020
1) Level block		CM0300M(R) -ooo		TB 1	3) Power supply line
(prepared by customers)
				CN 2
		5) Encoder cable
		CE7800M(R)-ooo

(3) Items to be checked		Check
			4
1)	Is the main body fixed on the level block?	"
2)	Is the motor not interfering with peripherals?	"
3)	Is the power supply line wired properly? (LINE, GND)	"
4)	Is the motor cable wired properly? (VA, VB, VC. GND)	"
5)	Is the encoder cable wired properly?	"
6)	Is the sensor wired properly?	"
	(Home position, OT sensor: driver (or positioning controller))
7)	Is the RS232C cable wired properly?	"
8)	Is RS-232C operation enabled?	"
	(Is bit 2 of PSW1 is on?)
9)	Is the wiring with the positioning controller done properly?	"
	(See a connection example on the following page.)

4-3