Parker Hannifin G2 Special Command Display, Operation Display Pendant, C M D R e f E r r S t s

9Operation Display Pendant

9.8Special Command Display

In this display, you can transmit selected commands to the controller.

The selection of the commands you can choose from depends on the main operation mode. They can be switched by pressing the f2/f6 SEL key.

When you select a command from the list and press the Return key, it is transmitted to the controller and the result of the command is shown in the display. By pressing the f2/f6 SEL key, it is switched to the command content display.

In the previous example of display 2), command “toMode15” is selected. When you press the Return key, this command is transmitted to the controller and the result of the command is displayed in display 3).

	Command	Display
Abort		CMD:Abort
Error reset		CMD:RstErr
Servo ON		CMD:SrvOn
Servo OFF		CMD:SrvOff
Mechanical setting operation start		CMD:toMode15
Software driver reset		CMD:RstDrive
Motor type request		CMD:MotorType
ROM version request		CMD:ROM Version
Error status request/refresh		CMD:RefErrSts
1) Initial display		f2	SEL:
		f3	N:
	CMD:Abort
	-Spc- SEL N/P	f6	SEL:
		f7	P:
2) Displaying command		Return key:

Switches command (positive).

To the next display

Switches command (opposite).

To the previous display

Transmits the selected command to the driver.

CMD:toMode15

-Spc- SEL N/P

3) Displaying command result

Mode15 Exec!

-Spc- SEL N/P

Command display area

C M D : R e f E r r S t s

- S p c - S E L N / P

Function key content

display area

Command result display area

N o	E	r	r	o r
- S p c -				S E L	N / P

Function key content

display area

9-8