Kenwood TM-D700E, TM-D700A instruction manual Fixed Station Operation, PS-33 20.5 A, 25% duty cycle

■Fixed Station Operation

1In order to use this transceiver for fixed station operation, you will need a separate 13.8 V DC power supply that must be purchased separately. The recommended current capacity of your power supply is 12 A.

1Connect the DC power cable to the regulated DC power supply and check that polarities are correct (Red: positive, Black: negative).

•DO NOT directly connect the transceiver to an AC outlet.

•Use the supplied DC power cable to connect the transceiver to a regulated power supply.

•Do not substitute a cable with smaller gauge wires.

2Connect the transceiver’s DC power connector to the connector on the DC power cable.

•Press the connectors firmly together until the locking tab clicks.

Fuse holder

Note:

◆	For your transceiver to fully exhibit its performance capabilities,
	the following optional power supply is recommended:
	PS-33 (20.5 A, 25% duty cycle).
◆	Before connecting the DC power supply to the transceiver, be
	sure to switch the transceiver and the DC power supply OFF.

Fuse holder

Red (+)

Black (–)

Regulated DC power supply

To AC outlet

◆ Do not plug the DC power supply into an AC outlet until you

make all connections.

6