Kenwood TM-D700A, TM-D700E Partial or Full RESET?, Parameter, Band B, 440.000 MHz

PARTIAL OR FULL RESET?

If your transceiver seems to be malfunctioning, initializing the transceiver may resolve the problem. Use Full Reset to initialize all settings that you have customized. Partial (VFO) Reset does not initialize the following settings:

Memory channels		Memory channel names
Memory channel lockout		Call channels
Program scan channels		PM channels
DTMF memory channels		DTMF memory channel
		names
Some of the VFO factory defaults are listed below:
Parameter	Band A		Band B
			440.000 MHz
VFO freq.	144.000 MHz		(U.S.A./ Canada) or
			430.000 MHz
Freq. step	5 kHz (U.S.A./		25 kHz
	Canada) or 12.5 kHz
Tone freq.	88.5 Hz		88.5 Hz

1Press [MNU] to enter Menu mode.

2Press [c]/ [d] to select “RADIO (1–)”, then press [OK].

3Press [c]/ [d] to select “AUX (1–9–)”, then press [OK].

4Press [c]/ [d] to select “RESET (1–9–7)”, then press [OK].

7

5Press [c]/ [d] to select Partial (VFO) Reset, PM Reset {page 45}, or Full Reset, then press [OK].

•A confirmation message appears.

•Press [ESC] to quit resetting.

6Press [OK].

After switching the power OFF, you may press [VFO]+ POWER ON for Partial Reset, or [MR]+ POWER ON for Full Reset. This allows you to skip steps 1 to 5.

You can also use the RESET button to perform Full Reset. See page 12.

Note: When in All-control Lock or Channel Display mode, you cannot perform Partial Reset nor Full Reset.

41