Kenwood TM-D700A, TM-D700E instruction manual Basic Transceiver Modes

BASIC TRANSCEIVER MODES

This section introduces you to the basic modes you can select.

VFO mode

Press [VFO] to select. You can change the operating frequency using the Tuning control or Mic [UP]/ [DWN].

Memory Recall mode

Press [MR] to select. You can change memory channels, using the Tuning control or Mic [UP]/ [DWN], where you stored frequencies and related data. Refer to “MEMORY CHANNELS” {page 35}.

3

Menu mode

Press [MNU] to select. You can change Menu Nos. using the Tuning control or [c]/ [d]. Refer to “MENU SET-UP” {page 22}.

APRS mode/ Packet mode

Press [F] (1 s), [TNC] to select APRS mode. Press [F] (1 s), [TNC] again to select Packet mode. In APRS mode, you can receive and transmit APRS packets. In Packet mode, you can send commands to the built-in TNC from a personal computer. Refer to the separate manual, “SPECIALIZED COMMUNICATIONS” {pages 4 and 11}.

Programmable Memory (PM) mode

Press [PM] to select. You can select the transceiver	2
environment, by pressing [1] to [5], that you stored in
PM channels. Refer to “PROGRAMMABLE MEMORY
(PM)” {page 42}.

1

APRS mode

2

1

Packet mode

15