Kenwood TM-D700E Recalling the Call Channel, Reprogramming the Call Channel, Press VFO

CALL CHANNEL

The Call channel can always be selected quickly no matter what mode the transceiver is in. For instance, you may use the Call channel as an emergency channel within your group. In this case, the Call/VFO scan {page 54} will be useful.

The default frequency stored in the Call channel is 144.000 MHz for the VHF band. The default on the UHF band is 440.000 MHz or 430.000 MHz depending on the market versions. The Call channel can be reprogrammed either as a simplex & repeater or odd- split channel.

Note: Unlike channels 1 to 200 the call channel cannot be cleared.

■Recalling the Call Channel

1 Select the desired band.

2 Press [CALL] to recall the Call channel.

•“CALL” appears.

• To restore the previous mode, press [CALL] again.

■Reprogramming the Call Channel

1 Select the desired band.

2 Press [VFO].

3 Select the desired frequency and related data (Tone, CTCSS, etc.).

•When you program the Call channel as an odd-split channel, select a receive frequency.

4 Press [F], [C.IN].

• The selected frequency and related data are stored	7
in the Call channel.

•The previous mode is restored.

•When programming as an odd-split channel, press [F], [C.IN] (1 s) instead; “±” appears.

To also store a transmit frequency, proceed to the next step.

5Select the desired transmit frequency.

6Press [C.IN].

•The transmit frequency is stored in the Call channel, and the previous mode is restored.

Note:

◆Transmit Offset status and Reverse status are not stored in an odd-split Call channel.

◆To store data other than frequencies, select the data in step 3 not step 5.

39