3
1
■Front Panel Installation
1Assemble the mounting brackets using the
supplied 2 hexagon SEMS screws and 2 flat
washers.
• Do not completely tighten the screws in this step.
2Peel off the paper backing from the rear of the
bracket.
3Position the bracket in the vehicle, then install it
securely using the supplied 3 self-tapping screws
and 3 flat washers.
4Position the grooves on the front panel over the
bracket tabs.
5Slide the front panel down until its locking tab
clicks.
• The tab on the front panel must be completely locked
by the bracket; otherwise vehicle vibration may
cause the front panel to drop off the bracket.
6Determine the angle of the front panel, then
completely tighten the 2 SEMS screws on the
bracket.
SEMS screw
Self-tapping screw
(4 mm x 14 mm)
Flat washer
Bracket tab
Locking tab
SEMS screw