Installing the VGS-1 Unit

Follow the instructions below to install the VGS-1 unit.

1 Remove the 8 screws from the cover of the base unit, then remove the cover itself from the unit.

2

From the 5 black cushions supplied with

cushion

 

the VGS-1, select the thickest rectangular

 

 

cushion (20 x 30 x 12 mm) and attach it to

 

 

the top surface of the VGS-1 unit.

VGS-1

 

• To prevent interferece to the terminal of the

 

 

 

VGS-1, ensure that you attach the thick

 

 

square cushion to the baseplate surface.

 

3

From the remaining cushions, select the

cushion

 

thickest square cushion (21 x 21 x 2.5

 

 

mm) and attach it to the printed circuit

 

 

board.

 

• The remaining cushions are not used with this transceiver.

• Ensure that the cushion is placed within the guidelines on the PCB.

guidelines

connector

4Insert the VGS-1 unit into the connector

on the transceiver.

• Press down on the top of the VGS-1 unit to ensure that it is securely attached to the connector.

5 Replace the cover on the base unit and secure it using the 8 screws.

93