Kenwood TS-2000, TS-2000X, TS-B2000 manual 132

21 APPENDIX

FR	Selects or reads the receiver VFO, M. CH or CALL/ COM.										Parameters:
											P1
											0: VFO A
	1	2	3	4	5	6	7	8	9	10
											1: VFO B
Set	F	R
			P1	;							2: M.CH
											3: CALL
	1	2	3	4	5	6	7	8	9	10
Read	F	R	;								The command is applied to the current CTRL (Control) band.
	1	2	3	4	5	6	7	8	9	10
Answer
	F	R	P1	;
FS	Selects or reads the FINE function status.										Parameters:
											P1
											0: FINE function OFF
	1	2	3	4	5	6	7	8	9	10
											1: FINE function ON
Set
	F	S	P1	;
	1	2	3	4	5	6	7	8	9	10
Read
	F	S	;
	1	2	3	4	5	6	7	8	9	10
Answer	F	S	P1	;
FT	Selects or reads the transmitter’s VFO, M. CH or CALL/ COM.										Parameters:
											P1
											0: VFO A
	1	2	3	4	5	6	7	8	9	10
											1: VFO B
Set	F	T
			P1	;							2: M.CH
											3: CALL
	1	2	3	4	5	6	7	8	9	10
Read											The command is applied to the current TX band.
	F	T	;
	1	2	3	4	5	6	7	8	9	10
Answer
	F	T	P1	;
FW	Selects or reads the DSP receive filter width.										Parameters:
											P1
											0000 ~ 9999 (in Hz)
	1	2	3	4	5	6	7	8	9	10
											CW: 50, 80, 100, 150, 200, 300, 400, 500, 600, 1000, 2000
Set	F	W
			P1	P1	P1	P1	;				FSK: 250, 500, 1000, 1500
											FM/AM: 0000=Narrow, 0001=Wide
	1	2	3	4	5	6	7	8	9	10
Read	F	W	;								In SSB mode, you cannot use the FW command. Use the SL
											or SH command instead.
	1	2	3	4	5	6	7	8	9	10
Answer
	F	W	P1	P1	P1	P1	;
GT	Selects or reads the AGC constant status.										Parameters:
											P1
											000=OFF
	1	2	3	4	5	6	7	8	9	10
											001 (min.) ~ 020 (max.)
Set
	G	T	P1	P1	P1	;
											GT commands cannot be used in FM mode. The transceiver
	1	2	3	4	5	6	7	8	9	10
											responds with 3 spaces when the GT command is used in
Read
	G	T	;								FM mode.
	1	2	3	4	5	6	7	8	9	10
Answer	G	T	P1	P1	P1	;

124