Setting up the system
Connecting the terminals
1 Strip coating. | 2 Loosen. | ||
|
|
|
|
3 Insert. | 4 Secure. |
1 Strip coating. | 2 Push the lever. | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3 Insert the cord. | 4 Return the lever. |
Connection of banana plugs
1 Secure. | 2 Insert. |
•Sound will not be heard if the speaker terminal is not fully secured.
•Never short circuit the + and – speaker cords.
•If the left and right speakers are connected inversely or the speaker cords are connected with reversed polarity, the sound will be unnatu- ral with ambiguous acoustic imaging. Be sure to connect the speakers correctly.
Speaker placement
Center Speaker
Front Speakers | Subwoofer |
| |
(L, R) | Listening |
Surround Speakers | position |
| |
(L, R) |
|
*Surround Back | *Surround Back |
Left Speaker | Right Speaker |
| *Surround Back Speaker |
*For Surround Back speaker, you may place either two Surround Back speakers (Surround Back Left Speaker and Surround Back Right Speaker) for 7.1 channel surround sound system or one Surround Back Speaker for 6.1 channel surround sound system.
Front (Left and Right) Speakers
Place at the front left and right of the listening position. Front Speakers are required for all surround modes.
Center Speaker
Place front and center. This speaker stabilizes the sound image and helps recreate sound motion. Required for surround playback.
Surround (Left and Right) Speakers
Place at the direct left and right, or slightly behind, the listening position at even heights, approximately 1 meter above the ears of the listeners. These speakers recreate sound motion and atmosphere.
Subwoofer
Usually, place the subwoofer in the front center position in the listening room, near one of the front speakers near the center speaker. (Since the subwoofer has less directivity than other speak- ers, it can be placed almost in any position that can offer the best low frequency reproduction according to the room layout.)
Surround Back Speaker/s
Place the surround back speaker behind the listining position, at the same height as the left and right surround speakers.
•Although the ideal surround system consists of all the speakers listed above, if you don't have a Center speaker or a Subwoofer, you can divide those signals between the available speakers in the
speaker settings steps to obtain the best possible surround
reproduction from the speakers you have available. | & |
Speaker impedance
After confirming the speaker impedance indications printed on the rear panel of the receiver, connect speakers with matching impedance ratings. Using speakers with a rated impedance other than that indicated on the rear panel of the receiver could result in malfunctions or damage to the speakers or receiver.