Kenwood XD-9581MD 2Before applying power, Safety precautions, Requirement By Nederland Gazette

Models: XD-9581MD

1 84
Download 84 pages 9.74 Kb
Page 2
Image 2
2Before applying power

2Before applying power

Preparation section Caution : Read this page carefully to ensure safe operation.

XD-9581MD (En)

Units are designed for operation as follows.

Europe and U.K

AC 230 V only

Preparation section

For the United Kingdom

Factory fitted moulded mains plug

1.The mains plug contains a fuse. For replacement, use only a 13-Amp ASTA-approved (BS 1362) fuse.

2.The fuse cover must be refitted when replacing the fuse in the moulded plug.

3.Do not cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach.

A power point, then obtain an appropriate safety approved extension lead or adapter, or consult your dealer.

If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent.

Connection to the mains supply.

IMPORTANT : The wires in the mains lead are coloured in accordance with the following code :

Blue : Neutral

Brown : Live

Do not connect those leads to the earth terminal of a three-pin plug.

Basic section

Application section

 

Safety precautions

WARNING

 

 

 

 

 

: TO PREVENT FIRE OR ELECTRIC SHOCK,

 

 

 

 

 

DO NOT EXPOSE THIS APPLIANCE TO

 

 

 

 

 

RAIN OR MOISTURE.

 

 

 

 

 

 

 

 

 

 

 

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER

 

 

 

CAUTION

 

 

 

 

 

 

 

(OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALI-

 

 

 

RISK OF ELECTRIC SHOCK

 

 

 

 

 

FIED SERVICE PERSONNEL.

 

 

 

DO NOT OPEN

 

 

 

 

 

 

 

 

 

 

 

 

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS IN-

 

 

 

 

TENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE”

 

 

 

 

WITHIN THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE

 

 

 

 

A RISK OF ELECTRIC SHOCK TO PERSONS.

 

 

 

 

 

 

 

 

 

 

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER

 

 

 

 

TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS

 

 

 

 

IN THE LITERATURE ACCOMPANYING THE APPLIANCE.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Knowledge sections

REQUIREMENT BY NEDERLAND GAZETTE

Batteries are supplied with this product. When they empty, you should not throw away. Instead, hand them in as small chemical waste.

The marking of products using lasers
(Except for some areas)

CLASS 1

LASER PRODUCT

The marking is located on the rear panel and says that the com- ponent uses laser beams that have been classified as Class 1. It means that the unit is utilizing laser beams that are of a weaker class. There is no danger of hazardous radiation outside the unit.

Page 2
Image 2
Kenwood XD-9581MD 2Before applying power, Safety precautions, Requirement By Nederland Gazette, For the United Kingdom