Kenwood XD-9581MD Pause the recording, Stop the recording Regard to display messages

Let's record

XD-9581MD (En)

29

Pause the recording

¦￿ 8

ÖPress the key again to resume recording. At this time, the track number is incremented by “1”.

ÖRecording can also be started by pressing the record (¦) key.

Stop the recording

73

In regard to display messages

Recording is not possible when one of the following messages is displayed.

“DISC FULL”	: The minidisc is full.
	\ Erase unrequired tracks. ä
“PROTECTED”	: The write protect tab is open.
	\ Close it.	5
“UNRECORDABLE”	: The minidisc is only for playback.
	\ Insert a recordable disc. j

Sampling Frequencies

Normally the following three types of digital signals are used and they are called sampling frequencies.

48kHz 44.1 kHz

32kHz

As this unit has a built-in sampling rate converter, digital signals of 32 kHz and 48 kHz are converted to 44.1 kHz for recording.

Preparation section

		ER/R	EC
	CT			L
A					E
R
A					V
H						E
						L
C
@
@
@
@
4						¢
−						+

	4
Level decreases		Level increases
Level value
18 15 12 9 7 5 3 1	0 OVER(-dB)
Display on the MD
	0dB
recorder section

¦￿ 8

5

EJECT

0

6

	Basic section
4. Adjust the recording level (only analog recording).

1Play the source to be recorded.

2Set to recording pause.

Always press the record (¦) key in stopped condition, and then press

the pause (8) key.

3Adjust the recording level.	ÖAdjustment is possible in the range from -∞dB
	to 0 dB (81steps).
	Applicationsection
	ÖAdjust so that 0 dB lights only once in a while.
	ÖLower the level when the red part of the level
	meter lights.

5. Start recording.

1Press the record (¦) key.	ÖDuring recording, the EJECT (0) key will not be
	accepted.

2Play the music source to be recorded. ÖTo start recording simultaneously with CD play- back, please read ”Tips for recording from a

	CD“.	¼	Knowledge
6.	Always remove the minidisc after recording.		sections
	Remove the minidisc after the end of recording.

“DISC WRITING” displayed during the minidisc ejection operation indicates that the data associated with recording or editing is being written on the disc. Do not apply vibration or shock to the unit while this message is displayed.