Keurig B155 owner manual Set-Up & First Brew, Setting Up Your Brewer

SECTION 1 Set-Up & First Brew

IMPORTANT: You cannot use your Keurig® Brewer until it has been set up for its first use.

NOTE: If Brewer has been exposed to temperatures below freezing, allow Brewer at least two hours to reach room temperature before brewing. A frozen or extremely cold Brewer will not operate.

fig. 2	4. Fill the Water Reservoir up to the
	fill mark with fresh, clean water.
	Replace the Water Reservoir on
	the Brewer making sure that
	the locking tabs engage with the
	Brewer (fig. 2). Replace Lid on
	Water Reservoir.
	5. The Brewer will automatically fill
	the Internal Hot Water Tank with
	water and then the water will

fig. 1

Welcome To The

Keurig B155 Brewing

System Designed

For The K-Cup®

Portion Pack

Español Français

Setting Up Your Brewer

1.Remove all pieces of packing tape for the brewer and Drip Tray. Remove the clear plastic film from the LCD Display. Unwrap cord and plug the Brewer into a grounded outlet.

2.Turn the Brewer on, the Power Switch is located at the top left hand side of the Brewer on the back. The Brewer’s LCD Display will display the power up welcome screen (fig. 1).

3.Remove the Water Reservoir from Brewer

by first removing Lid from the Water Reservoir then lifting the Water Reservoir straight up and toward the right of the Brewer (may be tight). Rinse the Water Reservoir thoroughly with fresh, clean water.

	be heated. This will take about
	3 minutes. During the heating
fig. 3	period, “HEATING PLEASE WAIT”

	will be displayed on the LCD
	Screen (fig. 3).
	6. Place a 10 oz. mug on the Drip Tray Plate,
	then fully raise and lower the Brewer Handle.
Heating...	The Brew Button will now be illuminated.
	Press the Brew Button to start a cleansing
Please Wait
	brew. NOTE: A K-Cup should not be used for
	this sequence.
	7. When the cleansing brew is complete, the
	Brewer will go into its idle state and will be
	ready to brew your first K-Cup®portion pack.

6