Keyspan USA-19Qi installation instructions Cx.02 Modem/Cell Phone PPP Setup, Before you begin

Keyspan:USB Serial Adapter for Mac OS X-v2.x User Manual

7.1.cx.02 - Modem/Cell Phone PPP Setup

Before you begin...

This Configuration Example shows you how to configure a dial-up internet connection (aka PPP connection) via the Network System Preference. In this example, a modem or cell phone is connected to a Keyspan serial port and the Network System Preference is told to communicate with that Keyspan serial port.

Before you begin, please make sure that you have done the following:

1.installed the Keyspan serial port hardware and software

2.connected the Modem/Cell Phone hardware to a Keyspan serial port

If you have not performed any of the steps mentioned above, please do so before proceeding.

Step 1 - Check the Keyspan Serial Assistant

Before proceeding, you should check to see if the Keyspan serial port is installed correctly.

To do this, open the Keyspan Serial Assistant (located in your Applications folder). When you open the Keyspan Serial Assistant, you will see a window similar to the one shown below:

the Keyspan Serial Assistant window

(continued on next page...)

This User Manual applies to the Keyspan USB Serial Adapter Software for Mac OS X.

Rev 05jul15 Page 22