KitchenAid 2200139A Door Closing, Base Grille, To remove the base grille, To replace the grille

25 and 27 cu. ft.	25 and 27 cu. ft.
Freezer door	Refrigerator door
panel dimensions	panel dimensions

Door Closing

Your refrigerator has 2 front adjustable rollers — one on the right and one on the left. If your refrigerator seems unsteady or you want the doors to close easier, adjust the

1/4"

(6.35 mm)

5/16"

(7.93 mm)

207/16"

(51.91 cm)

1415/16"

(37.94 cm)

633/8"

(160.97 cm)

1415/16" (37.94 cm)

1/4" (6.35 mm)

5/16"

(7.93 mm)

1911/16" (50.01 cm)

refrigerator's tilt using the instructions below:

1.	Plug in refrigerator.
2.	Move the refrigerator into its final position.
3.	Remove the base grille (see “Base Grille” earlier in this
	section). The two leveling screws are part of the front
	roller assemblies which are at the base of the
	refrigerator on either side.
4.	Use a screwdriver to adjust the leveling screws. Turn
	the leveling screw to the right to raise that side of the
	refrigerator or turn the leveling screw to the left to lower

5/16"

(7.93 mm)

1/4" (6.35 mm)

281/2"

(72.4 cm)

5/16"

(7.93 mm)

1/4" (6.35 mm)

that side. It may take several turns of the leveling

screws to adjust the tilt of the refrigerator.

NOTE: Having someone push against the top of the

refrigerator takes some weight off the leveling screws

and rollers. This makes it easier to adjust the screws.

3/4" min.	3 1/4"		3/4"		3 1/4"	3/4" min.		3/4"
(19.05 mm min.)	(82.55 mm min.)				(82.55 mm min.) (19.05 mm min.)
				(19.05 mm)				(19.05 mm)
						TOP VIEW
		TOP VIEW
			1/4"					1/4"
			(6.35 mm)				(6.35 mm)

Base Grille

To remove the base grille:

1.Open both refrigerator doors.

2.Place hands along the ends of the grille, with your thumbs along the top. Push in with your thumbs and pull up on the bottom.

NOTE: Be sure to refasten the Tech Sheet behind the base grille after cleaning.

To replace the grille:

1.Open the doors.

2.Line up the grille support tabs with the metal clips.

3.Push the grille firmly to snap it into place.

5.Open both doors again and check to make sure that they close as easily as you like. If not, tilt the refrigerator slightly more to the rear by turning both leveling screws to the right. It may take several more turns, and you should turn both leveling screws the same amount.

6.Replace the base grille.

11