KitchenAid 2200139A manual Factory Trim Kit, Removing the Door Panels, Connecting to refrigerator

Connecting to refrigerator:

1.Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. Use the tube clamp on the back of the refrigerator to secure the tubing to the refrigerator as shown. This will help prevent damage to the tubing when the refrigerator is pushed back against the wall. Move to step 2.

2.Turn shut-off valve ON. Check For Leaks. Tighten any connections (including connections at the valve) or nuts that leak.

1.Tube Clamp

2.Copper Tubing

3.Compression Nut

4.Valve Inlet

3.The ice maker is equipped with a built-in water strainer. If local water conditions require periodic cleaning or a well is your source of water supply, a second water strainer should be installed in the ¹⁄₄-inch water line. Obtain a water strainer from your nearest appliance dealer. Install at either tube connection.

4.Plug in refrigerator or reconnect power.

Factory Trim Kit

(on some models)

There may be an occasion when you will need to remove the factory-installed trim kit, such as moving the refrigerator to a new home or installing custom-made decorator panels. Please read all instructions carefully before removing the trim kit and decorator panels.

2 1

3

2	1	1	2
Freezer Door		Refrigerator Door

1.Decorator Panels

2.Filler Panels

3.Handles

Removing the Door Panels

NOTE: When removing and replacing decorator panels, only the handle is removed. All other trim pieces remain attached to the doors.

1.Remove the refrigerator and freezer handles:

■Using a Phillips screwdriver, remove the screws that hold each handle in place.

■Lift off handle. Make sure you keep screws for reattaching handles.

2.Remove the door panels:

■Open refrigerator or freezer door.

■Slide out decorator panel and filler board.

■Repeat process for other panels and filler boards.

■Store panel and filler boards carefully to prevent scratching.

9