7
3. Remove left top hinge.
■Remove hinge cover and screws. DO NOT
REMOVE SCREW 1 AS SHOWN IN DIAGRAM.
■Disconnect wiring plug and both ground wires.
■Carefully lift door up off bottom hinge. Make sure
you protect water line from damage.
4. Disassemble right top hinge.
■Remove hinge cover and screws. DO NOT
REMOVE SCREW 2 AS SHOWN IN DIAGRAM.
■Lift door up off bottom hinge.
5. Remove bottom hinge, if necessary. Both bottom
hinges have similar construction. DO NOT REMOVE
SCREW 3 AS SHOWN IN DIAGRAM.
NOTE: It may not be necessary to remove the bottom
hinge to move refrigerator through a doorway.
6. Replace doors.
7. Reconnect wiring plug and both grounding wires.
8. Replace hinge cover and screws.
9. Plug in refrigerator or reconnect power.
W ater System Preparation
Please read before using the water system.
Immediately after installation, follow the steps below to
make sure that the water system is properly cleaned.
1. Turn off the ice maker by opening the freezer door and
lifting up the signal arm as shown.
2. Flush the water system by dispensing and discarding
2-3 gallons (approximately 6-7 minutes) of water
through the dispenser. This will clean the system and
help clean air from the lines. Additional flushi ng may be
required in some households.
3. Turn on the ice maker by opening the freezer door and
lowering the signal arm as shown.
4. Allow 24 hours to produce the first batch of ice. Ice
maker should then produce approximately 7 to 9
batches of ice in a 24-hour period. Discard the first
three batches of ice produced.
1
2
3
WARNING

Electrical Shock Hazard

Reconnect both ground wires.

Failure to do so can result in death or

electrical shock.