KitchenAid KGSS907, KGSK901, KGRS807 manual Troubleshooting, To Replace, Nothing will operate

Models: KGSK901 KGSS907 KGRS807

1 56
Download 56 pages 6.93 Kb
Page 24
Image 24
TROUBLESHOOTING

3.Pull both loops forward at the same time, then pull drawer out another inch (2.5 cm).

4.Holding the drawer by its sides, not its front, gently pull it all the way out.

To Replace:

1.Align the drawer glides with the receiving guides.

2.Push drawer in all the way.

3.Gently open and close the drawer to ensure it is seated properly on the slides.

TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

 

Is propane gas being used?

Nothing will operate

The range may have been converted improperly. Contact a

 

trained repair specialist.

 

Nothing will operateWARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Is the power supply cord unplugged? Plug into a grounded outlet.

Has a household fuse blown or has a circuit breaker tripped?

Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.

Is the range properly connected to the gas supply? Contact a trained repair specialist or see the Installation Instructions.

Surface burners will not operate

Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines.

Is the control knob set correctly? Push in knob before turning to a setting.

Are the burner ports clogged?

See “Sealed Surface Burners” section.

Surface burner flames are uneven, yellow and/or noisy

Are the burner ports clogged?

See “Sealed Surface Burners” section.

On models with caps, are the burner caps positioned properly?

See “Sealed Surface Burners” section.

Surface burner makes popping noises

Is the burner wet? Let it dry.

Gas range noises during Bake and Broil operations

Noises that may be heard during the Bake and Broil operations: Whooshing, Poof, Clicking, Snaps, Pop

These sounds are normal operational noises that can be heard each time the Bake or Broil burners ignite during the cycle.

A pop can be heard when the gas valve is opening or cycling on and will make a single pop when it snaps open from the solenoid. It sounds similar to a suction cup being pulled off of a piece of glass.

The igniters will click several times until the flame is detected. These are short clicking sounds like tapping a nail onto a piece of glass.

A whooshing or poof sound is heard when the Bake or Broil burner ignites.

On some models, a clicking sound can be heard when the convection fan relay cycles on and off.

Burner sparks but does not light

Is there continuous sparking, but the burner does not light?

Discontinue use of the surface burner and contact a service technician.

Excessive heat around cookware on cooktop

Is the cookware the proper size?

Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than ½" (1.3 cm) outside the cooking area.

Cooktop cooking results not what expected

Is the proper cookware being used? See “Cookware” section.

Is the control knob set to the proper heat level? See “Cooktop Controls” section.

Is the range level?

Level the range. See the Installation Instructions.

24

Page 24
Image 24
KitchenAid KGSS907, KGSK901, KGRS807 Troubleshooting, To Replace, Nothing will operate, Surface burners will not operate