INSTALLATION INSTRUCTIONS
4.Install the water supply tube clamp around the water supply line to reduce strain on the coupling.
5.Turn shutoff valve ON.
6.Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.
7.On some models, the ice maker is equipped with a
Complete the Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
1.Plug into a grounded 3 prong outlet.
2.Flush the water system. See “Water and Ice Dispensers.”
NOTE: Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. Allow 3 days to completely fill the ice storage bin.
Handle Installation and Removal
Parts Included: Refrigerator door handles (2), Freezer drawer handle (1), ¹⁄₈" hex key, spare setscrew(s)
Install Handles
NOTE: Handle mounting setscrews are preinstalled inside the handle.
1.Remove the handles from the packaging inside the refrigerator, and place them on a soft surface.
2.Open a refrigerator compartment door. On the closed door, place a handle onto the shoulder screws so that the setscrews are facing the adjacent door.
3.Firmly push the handle toward the door until the handle base is flush against the door.
4.While holding the handle, insert the short end of the hex key into the upper hole and slightly rotate the hex key until it is engaged in the setscrew.
A
B
A. Shoulder screws
B. Setscrews inside the handle
5.Using a clockwise motion tighten the setscrew just until it begins to contact the shoulder screw. Do not fully tighten.
6.Repeat steps 4 and 5 to fasten the lower setscrew.
7.Once both setscrews have been partially tightened as instructed in the previous steps, fully tighten both setscrews.
IMPORTANT: When the screws feel tight, tighten them an additional
12
