KitchenAid W10417002A The water and ice, dispenser will not, operate properly, Troubleshooting

Models: W10417002A

1 84
Download 84 pages 41.65 Kb
Page 35
Image 35
The water and ice

 

 

TROUBLESHOOTING

 

 

 

PROBLEM

POSSIBLE CAUSES

SOLUTIONS

 

 

 

 

 

The water and ice

The refrigerator is not connected to a

Connect the refrigerator to the water supply and turn the

dispenser will not

water supply or the water supply

water shutoff valve fully open.

operate properly

shutoff valve is not turned on.

 

 

 

 

 

 

 

There is a kink in the water source line

A kink in the water line can reduce water flow from the water

 

 

dispenser and result in hollow or irregular shaped ice.

 

 

Straighten the water source line.

 

 

 

 

 

The refrigerator has just been

Flush and fill the water system. See “Water and Ice

 

installed.

Dispensers.”

 

 

 

 

 

The water pressure to the house is not

The water pressure to the house determines the flow from

 

at or above 35 psi (241 kPa).

the dispenser. See “Water Supply Requirements.”

 

 

 

 

 

A reverse osmosis water filtration

A reverse osmosis water filtration system can decrease water

 

system is connected to your cold

pressure. See “Water Supply Requirements.”

 

water supply.

 

 

 

 

 

 

 

The water filter may be clogged.

Remove the water filter and operate dispenser. If water flow

 

 

increases, your filter is clogged and needs to be replaced.

 

 

See “Water Filtration System.”

 

 

 

 

 

The water filter is installed incorrectly

Remove the water filter and reinstall. See “Water Filtration

 

 

System.”

 

 

 

 

 

The refrigerator door or freezer drawer

Close the door or drawer firmly. If it does not close

 

is not closed completely.

completely, see “The doors will not close completely.”

 

 

 

 

 

The refrigerator doors were recently

Make sure the water dispenser wire/tube assembly has been

 

removed.

properly reconnected at the top of the refrigerator door.

 

 

See “Refrigerator Doors and Drawer.”

 

 

 

 

 

Ice is clogged in the ice storage bin or

Remove the ice clogging the storage bin and delivery chute,

 

ice is blocking the ice delivery chute.

using a plastic utensil if necessary. Clean the ice delivery

 

 

chute and the bottom of the ice storage bin using a warm,

 

 

damp cloth, then dry both thoroughly. To avoid clogging and

 

 

to maintain a fresh supply of ice, empty the storage bin and

 

 

clean both the storage bin and delivery chute every 2 weeks.

 

 

 

 

The ice dispenser jams

Crushed ice is blocking the ice

Switch from crushed ice to cubed ice to clear the ice

while dispensing crushed

delivery chute.

dispenser. Then switch back to crushed ice.

ice

 

 

 

 

 

 

 

Water is leaking or dripping

The glass was not held under the

Hold the glass under the dispenser 2 to 3 seconds after

from the dispenser system

dispenser long enough.

releasing the dispenser lever.

NOTE: A few drops of water

 

 

 

after dispensing is normal.

 

 

 

 

 

 

 

Water continues to drip

The refrigerator has just been

Flushing the water system removes the air from the lines

from the dispenser beyond

installed.

which causes the water dispenser to drip. Flush the water

the first few drops.

 

system. See “Water and Ice Dispensers.”

 

 

 

 

 

The water filter was recently installed

Flushing the water system removes the air from the lines

 

or replaced.

which causes the water dispenser to drip. Flush the water

 

 

system. See “Water and Ice Dispensers.”

 

 

 

 

Water is leaking from the

The water line connections were not

See “Connecting the Water.”

back of the refrigerator

fully tightened.

 

 

 

 

 

 

 

Recently removed the doors and did

See “Refrigerator Doors and Drawer.”

 

not fully tighten water line connection

 

 

35

Page 35
Image 35
KitchenAid W10417002A The water and ice, dispenser will not, operate properly, The ice dispenser jams, the first few drops