KitchenAid W10417002A manual Refrigerator Leveling, Door Closing and Alignment, Remove the Handles

INSTALLATION INSTRUCTIONS

8.Repeat steps 2 through 7 to install the other handle onto the adjacent refrigerator door.

9.With the freezer drawer closed, place the handle onto the shoulder screws so that the setscrews are facing down toward the floor.

A

B

A. Shoulder screw

B. Setscrews inside the handle

10.Firmly push the handle toward the drawer until the handle base is flush against the drawer.

11.Insert the short end of the hex key into the left-hand hole and slightly rotate the hex key until it is engaged in the setscrew.

12.Using a left to right motion tighten the setscrew a quarter-turn at a time just until it begins to contact the shoulder screw. Do not fully tighten.

13.Repeat steps 11 and 12 to fasten the right-hand setscrew to the shoulder screw.

14.Once both setscrews have been partially tightened as instructed in the previous steps, fully tighten both setscrews.

IMPORTANT: When the screws feel tight, tighten them an additional quarter-turn. The handle is not properly installed without this extra tightening.

15.Save the hex key and all instructions.

Remove the Handles

1.While holding the handle, insert the short end of the hex key into a setscrew hole and slightly rotate the hex key until it is engaged in the setscrew.

2.Using a right to left motion loosen the setscrew a quarter-turn at a time.

3.Repeat steps 1 and 2 for the other setscrew. Slowly pull the handle away from the door or drawer.

4.If necessary, use a Phillips screwdriver to remove the shoulder screws from the door.

Refrigerator Leveling, Door Closing and Alignment

The base grille covers the adjustable brake feet and roller assemblies located at the bottom of the refrigerator below the freezer drawer. Before making any adjustments, remove the base grille and move the refrigerator to its final location.

Tools Needed: ¹⁄₄" hex driver

Tools Provided: ¹⁄₈" hex key wrench

1.Remove the base grille. Grasp the grille firmly and pull it toward you. Open the freezer drawer to access the brake feet.

NOTE: To allow the refrigerator to roll easier, raise the break feet by turning them counterclockwise. The front rollers will

be touching the floor.	2.	Move the refrigerator to its final location.
	3.	Lower the brake feet, by turning them clockwise, until the
		rollers are off the floor and both brake feet are snug against
		the floor. This keeps the refrigerator from rolling forward when
		opening the refrigerator doors or freezer drawer.

13