Klark Teknik DY11 7HJ Front panel, ACTIVE SPLITTER section, OUTPUT level meter dBu Dedicated peak

Front panel

ACTIVE SPLITTER section

All of the switches in this section are of the two-position latching pushbutton type. Each switch, unless otherwise stated, has an adjacent LED for on/off indication, where illuminated LED = switch is on, and extinguished LED = switch is off.

1 OUTPUT level meter (dBu): Dedicated peak

reading, four-segment audio level LED meter that follows the output level at all times, no matter how the controls are set. The segments are: -15dBu (green); 0dBu (green); +12dBu (yellow); and +21dBu (red). Illumination of the red LED indicates the signal is being clipped.

2 Yellow LED for SOLO switch.

3 SOLO switch: Switches solo on/off. With solo on,

post mic amp gain audio is sent to the PHONES output, allowing you to listen to and monitor the audio content locally.

4 GAIN control knob: Nine-way control knob adjusts

the amount of mic gain added to the input signal before it is sent to the electronically balanced outputs. Range is from 0dB to +40dB in 5dB steps.

Note: The transformer isolated outputs are derived before the mic amp gain stage and are buffered and driven at -6dB operating gain, with no user adjustment available.

5 Yellow LED for 30Hz switch.

6 30Hz switch: Switches the 30Hz high pass filter

on/off. Operating at 30Hz, the filter acts as an ‘anti- rumble’ filter, which aids the removal of unwanted high energy low frequency elements in the audio signal.

1

9

8

2

3

4

5

6

7

7

8

Channel number and write-on panel.

+48V switch: Switches the +48V phantom power supply on/off.

Additionally, there is the facility of phantom power sensing provided on all electronic outputs that remotely enables +48V on the splitter mic input XLRs when phantom power is activated from any attached console. This is indicated by the illumination of its associated LED.

9 Red LED for +48V switch. This LED is for +48V switch on/off indication, but also illuminates when

phantom power is detected on either or both of the output XLRs (rear panel), even when the +48V switch is off.

10 Square ONE Splitter