Klark Teknik DY11 7HJ manual Operation

Operation

Operation

Basic operation

Caution:

Never apply phantom power to any unbalanced input source. Before powering the unit, always check the +48V status of any phantom powered equipment connected to any of the 16 output XLRs on the rear panel. If +48V is detected on any of these outputs the unit will apply +48V to any devices connected to their corresponding inputs (front or rear panel) as soon as the unit is powered up.

Connect all condenser mics and active DI boxes to the Square ONE Splitter before applying phantom power. Ensure that the sound system level is turned down at this stage to prevent switch-on thumps or acoustic feedback. The phantom power should be switched off for any channel being used with a dynamic mic or passive DI box, although there shouldn’t be any problems if the phantom power is inadvertently left switched on provided the sources are wired for balanced operation and connected using conventionally wired balanced cables.

Use the solo facility to check the level of each input individually and set the gain to achieve the highest possible signal level without clipping, that is, without the red LED of the OUTPUT meter illuminating. Leave sufficient headroom to allow for unplanned increases in level during performance.

Both the transformer isolated and electronically balanced outputs offer exceptional audio quality combined with excellent line driving capability. However, the transformer outputs may be preferred in situations where absolute electrical isolation must be maintained, such as running feeds to mobile studios or outside broadcast facilities. The fixed gain of the transformer outputs will also be preferable for broadcast trucks because they can have totally independent control of their system gain, headroom etc.

In theory, the electronically balanced outputs remove any opportunity for the audio transformers to colour the sound. However, in practice the sonic quality of the two types of output is very similar.

Solo bus operation

At the required channel, press the SOLO switch to switch solo on for that channel; its yellow LED (just above) will illuminate to show that solo is switched on. Soloing a channel switches its signal onto the internal solo bus, which allows it to be monitored in isolation via the headphone socket on the front of the unit. You can solo more than one channel at a time.

Using headphones

To hear any soloed channel(s) over the headphones, plug them into the PHONES socket at the right-hand side of the front panel. The socket is a standard 1/4” TRS jack, which will accept any set of conventionally wired stereo headphones. Adjust the volume using the LEVEL control knob.

14 Square ONE Splitter