Klark Teknik DY11 7HJ manual Rear panel, Red LED for OUTPUT A LIFT switch, Square ONE Splitter

Rear panel

Media split and ground lift switches

The output lift and media split switches are deliberately recessed to prevent them being inadvertently switched on or off. Each switch has an LED above for on/off indication, where illuminated LED = switch is on, and extinguished LED = switch is off.

1 Red LED for OUTPUT A LIFT switch.

2 OUTPUT A LIFT switch: Recessed switch for

globally disconnecting the internal ground from the OUT A output connector on all eight channels.

3 Red LED for OUTPUT B LIFT switch.

4 OUTPUT B LIFT switch: Recessed switch for

globally disconnecting the internal ground from the OUT B output connector on all eight channels.

5 Yellow LED for MEDIA SPLIT switch. This

LED is duplicated on the front panel; see “ACTIVE

SPLITTER section” on page 10.

6 MEDIA SPLIT switch: Recessed switch for

switching the unit to media split mode; see “Media split mode” on page 15 for details of operation.

Mains supply

1 IEC socket: Auto voltage sensing, switch mode

power supply that operates where the nominal mains voltage is in the range 100V a.c. to 240V a.c.

2 Fuse drawer: Contains the mains fuse at the

rear of a two-compartment drawer. The front compartment contains a spare fuse. Always replace the mains fuse (and spare) with the same type and rating; see “Checking/replacing the mains fuse” on page 28 for details.

3 Supply voltage and fuse specifications:

Details of the supply voltage and the mains fuse are printed here.

1

2

3

4

5

6

1 2 3 4

4 Fuse warning information: Details on replacing the mains fuse with the same type is printed here.

Square ONE Splitter 13