Klark Teknik DY11 7HJ manual Technical specification, Inputs Mic/line

Technical specification

Technical specification

Inputs	8 (mic/line)
	Type	Analogue, electronically balanced, female XLRs (Pin 2 hot)
	Maximum input level	+22dBu
	Input impedance	5k ohms
	Common mode rejection	-80dB at 1kHz (typical), unity gain (0dB)
	ratio (CMRR)	-100dB at 1kHz (typical), maximum gain (+40dB)

Outputs	16 (rear panel)
	Type	Analogue, electronically balanced, male XLRs (Pin 2 hot)
	Operating level	0dB
	Maximum level	+22dBu
	Output impedance	<50 ohms
	Signal drive capacity	<600 ohms

8 (front panel)
Type	Analogue, transformer isolated balanced, male XLRs (Pin 2 hot)
Operating level	-6dB
Maximum level	+22dBu
Output impedance	<75 ohms
Signal drive capacity	<600 ohms

Headphone	1
output	Type	Analogue, TRS jack socket
	Rating	750mW (nominal 50 ohm load)
Terminations	Audio	Front panel connectors
		Channel input: eight x AA series female XLRs (labelled “IN 1” to
		“IN 8”)
		Isolated output C: eight x AA series male XLRs (labelled “TX OUT 1”
		to “TX OUT 8”)
		Headphone output: one 1/4” TRS balanced jack socket
		Rear panel connectors
		Channel input: eight x AA series female XLRs (labelled “IN 1” to
		“IN 8”)
		Electronic output A: eight x AA series male XLRs (labelled “OUT A”)
		Electronic output B: eight x AA series male XLRs (labelled “OUT B”)
	Power	3-pin IEC
Performance	Frequency response1	±0.5dB (input to output), 20Hz to 20kHz
	Distortion	<0.02% @ 1kHz, 0dBu at unity gain
	Dynamic range2	Electronically balanced outputs: >122dB*
		Transformer isolated outputs: >140dB*
	Noise floor3	Unity gain <-100dBu*
		Mic EIN @ +40dB gain <-128dBu*
High pass	Filter frequency	-3dB @ 30Hz
filter	Filter slope	12dB per octave
Power	Voltage	100VAC to 240VAC ±10%
Requirements	Frequency	50Hz to 60Hz
	Consumption	<35W

20 Square ONE Splitter