![](/images/new-backgrounds/1171190/171190105x1.webp)
•HDMI 1/HDMI 2: Enables or disables the HDMI 1 and HDMI 2 sources.
•RGB: Enables or disables the RGB source.
•Comp 1/Comp 2: Enables or disables the Component 1 and Component 2 sources.
•Video: Enables or disables the Composite video source.
Note | If either Component 1 or Video is enabled, SCART must be disabled. |
|
•
•SCART: Enables or disables the SCART RGBS source.
Note | If SCART is enabled, both Component 1 and Video must be disabled. |
|
•Auto Power Off: Set Auto Power Off to On to have theLED1081 turn itself off after 20 minutes of inactivity (no source signal present).
•Auto Power On: Set Auto Power On to On causes the projector to automatically power up when AC power is present. If the projector is plugged into a switched AC outlet, this allows the projector to be turned on using a wall switch instead of the remote control unit. If you do not need this capability, set Auto Power On to Off (this is the de- fault setting).
•Rear Projection: This control reverses all images and menus, and is necessary when the projector is used in rear- projection applications. The default is Off.
•Ceiling Mode: This control flips the image so the projector can be used in ceiling mounted installations.
•
•LED: Triggers the screen when the LED is turned on.
•16:9, Letterbox, 4:3, or 4:3 Narrow: Triggers the screen when the selected aspect ratio is active.
•RS232: Triggers the screen when the RS232 “Trigger On” command is received.
•
Note | Trigger commands are deactivated when a PIP source is active. |
|
•Factory Reset: Select Factory Reset to restore all projector settings - except those listed below - to their
•LED Hours
•Model Name / Serial Number
•Language
•User Memory 1 / User Memory 2
Operation 53