Vertical and Horizontal Position | Knoll Systems LED1081 manual

Vertical and Horizontal Position

Proper placement of the projector relative to the screen will yield a rectangular, perfectly-centered image that com- pletely fills the screen.

Ideally, the projector should be positioned perpendicular to the screen.

The lens center should be aligned with either the top or bottom edge of the screen areas. The lens should be centered in the middle of the screen. See Figure 3-3.

Ceiling Installation

Ceiling

Height	Projection Distance

x

Lens Center

Lens Center

Screen

Floor Installation

Height

Lens Center

x

Screen

Lens Center

Projection Distance

Floor

Figure 3-3: Projector Placement

	Note	When installing, ensure that you use only UL Listed ceiling mounts.
	Note	For ceiling installations, use approved mounting hardware and M4 screws with a maximum screw

		depth of 8 mm (0.31inch).
		The construction of the ceiling mount must be of suitable shape and strength. The ceiling mount
		load capacity must exceed the weight of the installed equipment, and as an additional precaution
		be capable of withstanding three times the weight of the equipment (not less than 48 kg) over a
		period of 60 seconds.

20Installation

Image 20

Knoll Systems LED1081 user manual Vertical and Horizontal Position, Floor Installation

Contents

Projector Table of Contents Maintenance and Troubleshooting Copyright Information CopyrightDisclaimer About this manual Important Safety Instructions FCC Part Introduction About This ManualTarget Audience Textual and Graphic Conventions Turn to Using This ManualIf you need Description, Features and Benefits Key Features and Benefits Additional Features of the LED1081 Parts List Controls and Functions LED1081 at a Glance LED1081 Top/ Rear/ Bottom View LED1081 I/O Panel Component LED10801 Key Pad Source LED1081 Remote Control CONT, BRIGHT, Sharp Installation Remote Control IR Reception Angles Installation Considerations Installation TypeAmbient Light Advantages Considerations Throw Distance Estimated Throw Distance Floor Installation Vertical and Horizontal Position Folded Optics Other Considerations Lens Shift Vertical Lens Shift 15H Adjusting the Projection Angle Mounting the LED1081Floor Mounting Upright Ceiling Mounting Inverted Connecting Source Components to the LED1081 Connections to the LED1081 RGB Connections Component Video Connections 10 Composite and S-Video Connections RS-232 Controller Connection 11 RS-232 Control System Connection Connecting an External IR Receiver Connecting to AC Power Turning on the Power Adjusting the Picture OrientationCeiling Mode Changing the OSD Language Zoom Lens AdjustmentsFocus Vertical Lens Shift Horizontal Lens Shift Using the On-Screen Menus OperationSelecting an Aspect Ratio Selecting An Input Source LED1081 OSD Menu Structure General PIP PIP Split Mode Memory Sub-Menu Image Aspect Ratio Settings Below Black Above Black 10 Typical Gray Bar Pattern for Adjusting Contrast 12 Typical Test Pattern for Adjusting Sharpness 13 Noise Reduction Sub-Menu 14 Overscan Examples 15 HSG Sub-Menu Advanced OperaTion 4 17 RGB Adjust Sub-Menu 18 Fine Sync Sub-Menu Setup Trigger commands are deactivated when a PIP source is active Info Cleaning the Air Vents TroubleshootingMaintenanceCleaning the Intake and Exhaust Vents Troubleshooting Tips Symptom Possible Causes Solution Specifications Serial Interface SpecificationsTransfer Specifications RS-232 Commands IR Codes and Keynames Remote Button Description IR Codes and Keynames Function Command Action on unit Operation Command Values = RGB = PBP = LED Operations Commands Electrical LED1081 SpecificationsOptics Standard Accessories Mechanical LED1081 Dimensions Shows the LED1081 dimensions, in millimeters Supported Timings Sdtv Projection Distance and Screen Size Specifications Specifications Specifications