. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8-58 Reference— Kodak Driver Software“Camera battery is low.
To continue working, use
the AC adapter.”
The battery needs
charging.
If you are operating without the AC
adapter but are in an environment
where power is available, attach
the adapter, wait for a short time
and try again.
If neither a power source nor an
adapter is available, you will not
be able to complete this operation.
We encourage you to charge the
battery for two hours before any
field operations.
NOTES: If the battery in the camera
is not sufficient for your needs,
consider obtaining a Quantum
Battery 5 (QB5). Kodak produces
an accessory cable that allows you
to attach the camera system to the
QB5. (Neither the QB5 nor the
cable accessory is supplied with
the camera system.)
“Camera firmware was
loaded successfully.”
You clicked Load
Camera Firmware; the
operation was successful.
Click OK; no other action is
required.
“Camera ‘Self Test’
completed successfully.”
The self test you initiated
completed successfully.
Click OK; no other action is
required.
“Camera ‘Self Test’ failed.
Click the ‘Load Camera
Firmware’ button and
then try the 'Self Test'
button again.”
An unspecified hardware
problem occurred.
Try again. If the problem
continues, load camera firmware,
and try again.
If you continue to have problems,
contact Kodak.
Message Possible Cause Suggested Solution