Kodak DCS 410, DCS 420, DCS 460, NC2000e Accessing the Camera from the Driver

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

4-36 Preparing the Camera and the Computer

Accessing the Camera from theDriver

Repeat the steps below each time you want to access the KODAK Driver

for Adobe Photoshop software or for supported TWAIN-compliant PC

applications.

1. If the camera and your computer are not connected, turn both off and

connect them now by following the directions in “Making the SCSI

Connection” earlier in this chapter.

2. Connect the AC battery charger/adapter to the camera as described

earlier in this chapter. Although this step is optional, we recommend it

whenever the camera is connected to a computer.

3. If your computer is on, turn it off.

4. Turn on the camera by sliding the Nikon N90s power switch to ON.

5. Wake the camera by lightly pressing the shutter release button.

6. Turn on the computer.

7. Run Adobe Photoshop. (The examples throughout this manual use

Photoshop —available for both the Macintosh and PC platforms.)

NOTE: You should ensure that the gamma for your monitor is calibrated properly

per instructions accompanying Adobe Photoshop; if you do not, images may be

consistently too light or too dark.

All TWAIN-compliant software does not provide access to TWAIN drivers

in the same way. As a result, for demonstration purposes this section

provides one example using the KODAK Driver with Adobe Photoshop.