. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-26 Preparing the Camera and the Computer
B. PC (for TWAIN driver)The camera can be used with an IBM or compatible laptop computer if
you use a PCMCIA-to-SCSI II adapter (such as the Adaptec SlimSCSI used
with EZ-SCSI 4.0 or the New Media Bus Toaster). These adapters include
a PCMCIA card that plugs into the PCMCIA slot in your laptop (not in the
camera). A cable connects this card to the SCSI connector on the camera,
using an adapter if needed at the camera end of the cable. None of this
equipment is provided with the camera.
In this configuration set the SCSI ID on the camera to “PC;” this sets the
camera SCSI ID to 1 and turns on active termination in the camera.
CAUTION: When you finish with the camera in “PC” mode, turn off the com-
puter and camera. If left in “PC” mode, a fully charged battery will be exhausted
in approximately eight hours since the camera can not change to low power
mode when this SCSI setting is active.