A-61133 March 2003 D-5
3890 film, Film tab template settings
The information below includes only the values that are different from
the system default settings. For more information about the Film tab,
see the section entitled “Setting values on the Film tab” in Chapter 4.
Template specific settings
1. Film Format: Duplex.
2. Film Reduction: 50.
3. Overscan Images Before: 1.
4. Overscan Images After: 2.
5. Image Area: User Defined.
6. Auto Scan Length: Enabled.
Explanation of settings (see the illustration that follows)
1. Film Format: The format must be Duplex.
2. Film Reduction: The reduction must be 50X.
3. Overscan (Images Before and Images After): Due to the large
reduction ratio, poor image alignment within the film frame, and the
small distance between image marks, Overscan must be used. No
more than 6 images should be scanned at one time.
4. Image Area: Since Auto Scan Length determines only the scan length,
the Image Area setting must be used to determine scan width. A User
Defined image area setting was used. This setting may need to be
modified so the specified scan width accommodates your specific
needs, i.e., to eliminate the image marks (or other extraneous
information outside the image) for display and processing. Be sure to
specify an area that accommodates large business-size checks, and
allows for potential image location irregularity on the film, to prevent
truncation of images.
5. Auto Scan Length: Allows the software to determine scan length
based upon the distance between image marks.