Kohler CFI230G manual Temperature Control Timeout Minutes Knob Position

The lock mode may be activated when the unit is OFF in which case the unit cannot be switched ON unless the mode is cancelled as above.

Removing power from the unit also cancels the mode

4. Timeout

Note! Timeout allows you to run the shower for a set period of time before it automatically shuts off. This can only be set when the unit has not been used for a period of 10 minutes.

4.1.Timeout Selection - Set the temperature control knob to the desired position, as per the table below.

Temperature Control	Timeout (Minutes)
Knob Position
1	30
2	30
3	3
4	4
5	5
6	6
7	7
8	8
9	9

4.2.Enabling - Press and momentarily hold the Warm Up and Low keys at the same time.The two keys will flash twice and beep three times to confirm the selection is successful.

20 CFI230G

Carefully lift the assembly onto the tray. The end
of the glass panel fits into slot ‘A’ on the tray.
The wall channel end sits on the flat section of
the tray ‘B’
B
A
Take care not to
damage pipe and
cable protruding	STEP
from wall	14

Spot drill through 4 fixing holes in the wall jamb and mark the wall. Only 4 of the 8 holes are using alternate sides ‘A’.

Carefully remove the panel from the tray

A

STEP

16

Adjust wall jamb until glass is parallel to the edge of the tray ‘A’ and vertical at ‘B’.

	B
A
	STEP
	15
Drill 4 x 8mm holes	Fit plugs
	B
Carefully lift the panel
back into postion
Loosely fit
4 x A screws
	A
	Seal behind
	the wall channel
	and tighten
	screws
	STEP
	17
	CFI230G 9