Control Assembly
1.Pull off the temperature knob.
Concealing Plate
2.Carefully separate the concealing plate from the backplate.
Note! Use a screwdriver in the cutout to assist separation.
3. Fit the backplate to the shower control and secure with the three securing screws (removed from the
Note! If the finish is particularly uneven (i.e. due to grout lines), apply a small amount of silicone sealant to ensure a seal.
Caution! Do not overtighten the screws as this may cause the backplate to distort, preventing the fitting of the control knobs.
4.Align the flow control hub with the taper towards the top of the shower control (refer to illustration).
Cutout
Flow Control Hub
Temperature Knob
Backplate | Securing Screws | |
(Seal on Rear) | ||
|
19
