Kolpak DA-98 manual User setups, Saving user setups

3) WithinSDrtyervmenusvogroupetalDrFverSyncverF, moverothentvsearchcursorerso that it is by the Drsearchfield. The number of

whole hours that the000head2has b en in use for fast forward and fast rewind will be shown on the bottom line of the display.

14.2 Memory backup

Section 14Se– Maintenancetup and memory setups

3) Move theScursorvto 1123ad, 2yor 3?, and press the UP or DOWN key:

The DA-98 includes non-volatile memory (NVRAM) which preserves almost all user set- tings after the power is turned off.

14.3 User setups

You can save commonly-used setups in one of three user setup memory banks: 1, 2 or 3. This enables you to pre-configure the DA-98 for differ- ent jobs (video or film post-production, or differ- ent recording setups, for example). There is also a preset memory bank which contains the factory settings (see below).

When the DA-98 is shipped, the contents of all setup memories are the same; they contain the fac- tory s ings.

14.3.1 Saving user setups

1)	GoSetupo menu group 9, move the cursor to
		anduLpoapressd1ENTER:23F
2)		:tup
	To store the current setup, use the UP and
	DOWNSavekeys so that the bottom line reads
		Save	123

4) The word Ready?will flash on the screen. To

save the current setup to the selected setup m mory, press the UP or DOWN key.

The word Donewill appear on the screen for about 2 secondsupand the user settings will be stored o the selected setup memory bank.

14.3.2 LoadingLoaduser setups123F

1) SetupGo o menu group 9, move the cursor to and press ENTER:

2) ToSloadettheuLposetupad12memory into3theFcurrent memory, use the UP and DOWN keys so that the bottom line reads Load:

Setup

3) Move the cursor to 1, or 3, and press the UP or DOWN key:

Lad12Ready2?3F

The word Donewill appear on the screen for about 2 seconds..

The contents of the currently-selected setup will be loaded into memory.

06/97 – 1.00 – 14-3