Kolpak DA-98 manual Track mapping, Timecode track mapping, Tr k mapping and press Enter

2)100Use the UP and DOWN keys to select between and 8.

To determine whether your controller is sending

(a)locate commmands or (b) fast wind com-

mands, enter a locate operation from the remote controller.

If a true location command is being sent, the screen display will show the location point for a few seconds and only the fast forward and rewind keys will light. If the second type of command is received, the display will not change, and the fast forward and rewind indicators will light steadily, and the SHUTTLE indicator will flash.

11.1.6 Track mapping

When a controller arms and records on tracks, you need to specify which tracks on the controller cor- respond to particular tracks on the DA-98. The video controller protocol allows for control of up to eight digital and four analog audio tracks. The setting described here allows you to map control- ler tracks to DA-98 tracks.

This mapping does not imply any correspondence between the user interface of the controller and the DA-98 tracks–it refers to the relationship between

the command signals transmitted by the controller and theaDA-98 tr cks. The relationship between theAnuser interface1234of the controller and the com-

1) MapGoTtormenuckMgroupap6,pimovengthe cursor to Trk

m Dignd signals must be determined12using34the con- trollerTrkitself.5678

(tr k mapping) and press ENTER:

The lines above show the analog and digital tracks to which the DA-98 tracks on the bottom line are currently assigned.

The terms “analog” and ‘digital” used here have nothing to do with whether tracks actually are ana- log or digital. They correspond to the “Analog” and “Digital” tracks which the controller uses.

In the assignment above, therefore, when the con- troller refers to analog track 3, it is actually

Section 11 – External control

addressing DA-98 track3, and when referring to digital track 4, it is addressing DA-98 track 8.

2)Use the UP and DOWN keys to select the track mapping for use with your setup. The pre-set options available are shown below:

DA-98	1	2	3	4	5	6	7	8
track ⇒
Analog	￿		!"
Digital					￿		!"
Analog
Digital					#	$	%&
Analog			!"		￿		!
Digital
Analog	￿	￿			!!""
Digital
Analog
Digital			!"		￿		!
Analog
Digital	￿	￿			!!""

There are no user-settable track mappings, but the pre-set mappings are designed to cover every cir- cumstance.

11.1.7 Timecode track mapping

This is a special instance of track mapping, where the track corresponding to analog track 3 in the controller’sTCRecocommandrsigEnaalsbislmappedeeither to the digital audio t ack selected above (11.1.6, “Tra k mapping”), or to the DA-98’s dedicated timecode track. disable

1) GoRecENto menu gr up 6, move the cursor to TC and press ENTER:

06/97 – 1.00 – 11-3