Kolpak DA-98 manual Assigning menus to function keys, To assign a menu screen to a key

Lo5c–aMteP0nu0moprienrati-1r0osnslelc

5)Press the F 10 key [22] (to enter a 0):

6)PressLothecaFt5e0key1Pm[13]:rien-0r5oslelc

7)The numbers for this value have now been entered, but the value itself has not. Press the LOC 2 (PRESET) key [23] to enter the value.

The bottom line of the display will stop blinking.

8)You can use the UP and DOWN keys to adjust the value you have just entered.

9)Press SHIFT again to restore the function keys to their “non-function” values.Section

NOTE

Some parameters (e.g. offsets) can take either positive or negative values. To change the sign of the value, use the MEMO 2 (+/–)key [14] to toggle between posi- tive and negative values.

You can use the funct on keys as number keys in almost any menu where irect numerical input is possible.

You cannot use th se keys as number keys when th re are only two choices (even if they are RechaseModenumerical). An example of such a menu is the

me u (page 10-13), where the

two options for the Windowvalue are 1 second and 2 seconds. This parameter should be set using the UP and DOWN keys, not the number keys.

5.3 Assigning menus to function keys

It is quite likely that you will find yourself using a few of the same menu functions many times (for instance, manual adjustment of punch points) and

many of the menu functions only rarely (for instance, whether the DA-98 is a master or a slave unit).

Some of the keys below the tape co nter ([9] through [13], and [18] through [22]) can be used as “soft keys”, providing instant access to the menu screens you use most often.

5.3.1 To assign a menu screen to a key

1)Set the function key mode to Menuas described in 5.2, “Function key modes”

2)Use the cursor and ENTER keys to get to the menu functionFunctyouioPwantntoreasseignto a key.

3)Press"thePSHIFTshFukey [24]ctionK(the i dicatoreywill" flash).

4)Press the PRESET key [23]. The following will appear on the display.

5)Press the key (F 1 through F 10) to which you want to assign the menu screen.

This will assign the menu screen to the key and the SHIFT indicator will go out.

5.3.2Recalling an assigned menu function

1)Press the SHIFT [24] key (the indicator will flash).

2)Press the F key (1 through 10) which has been assigned to the menu function you want to recall.

The menu screen will be recalled, and the SHIFT indicator will go out.

5-4 – 1.00 – 06/97