Edit section

23

1

4

1. EFFECT

In this section you can select the type of effect and adjust various parameters.: supports motion se- quence.

TYPE (effect type): Selects the type of effect.

FX EDIT1 (effect edit 1) : Adjusts the effect. The actual parameter being controlled will depend on the effect type.

FX EDIT2 (effect edit 2) : Adjusts the effect. The actual parameter being controlled will depend on the effect type.

FX CHAIN (effect chain): On the ESX-1, the output of one effects processor can be fed to the input of another. The connection will change each time you press this, and the connection that is lit will be used.

EDIT SELECT: Chooses which effects processor is currently being edited.

MOTION SEQ. (motion sequence): Records and plays back movements of the FX EDIT1 and FX EDIT2 knobs. This will alternate between on (lit) and off (dark) each time it is pressed.

2. PART COMMON

These are the parameters that are common to the drum parts and to the keyboard parts. : supports motion sequence.

MOTION SEQ. (motion sequence): Turning this function on will allow you to record and playback knob movements for each part. This key will change successively between on (SMOOTH lit), on (TRIG HOLD lit), and off (dark) each time it is pressed.

PITCH/GLIDE : For a drum part, this knob sets the pitch. For a keyboard part, it specifies the time it takes for the pitch to change smoothly between two legato notes.

EG TIME : Adjusts the envelope time (the time it takes for the note to decay) for each part.

PAN (panpot) : This controls the position of the

2.Partsand their functions

part in the stereo field for the line outputs (L/MONO, R) or headphones. If a part is set to the individual (3/4) output bus (☞ p.26: Output bus) this control will adjust the panning to the individual outputs (INDIV. OUT 3, 4).

LEVEL : Adjusts the volume of each part. For an accent part, this will adjust the strength of the accent.

START POINT : Sets the playback start point for the sample assigned to each part.

AMP EG : Selects the amp envelope shape for each part. The envelope will alternate between (decay) or (non-decay) each time you press this.

ROLL : For each part, this will switch the roll effect on (lit) or off (dark).

FX SELECT (effect select) : Selects which effect processor will be applied to each part. If FX SEND is on, the selected effect will be applied. This setting is ignored for parts whose output bus (☞ p.42: Output bus) setting is 3/4.

FX SEND (effect send): Selects whether the sound of the current part will be sent to the selected effect. This will alternate between on (lit) and off (dark) each time it is pressed. This setting is ignored for parts whose output bus (☞ p.42: Output bus) setting is 3/4.

REVERSE : Selects whether reverse playback will be used for each part. This will alternate between on (lit) and off (dark) each time it is pressed.

3. MODULATION

These are the parameters such as LFO and EG that create time-varying changes in the sound.: supports motion sequence.

SPEED : Adjusts the modulation speed.DEPTH : Adjusts the modulation depth.TYPE (modulation type) : Selects the type of modulation.DEST (destination): Selects which parameter will be affected by the modulation.

BPM SYNC : Turning this on (lit) will cause the modulation to be in sync with the current tempo.

4. FILTER

These parameters modify the tonal character of the part. : supports motion sequence.

CUTOFF : Adjusts the cutoff frequency of the fil- ter.EG INT (EG intensity) : Adjusts the depth of the filter envelope.RESONANCE : Adjusts the resonance of the fil- ter.TYPE (filter type) : Selects the type of filter.

11