EG TIME ......................................................................

0...127

Specifies the EG decay time. The Amp EG setting determines how the volume will decay.

This parameter is valid when the AMP EG is “” and when the filter EG INT is other than 0.

GLIDE ..........................................................................

0...127

“Glide” (also called “portamento”) is a function that produces a smooth change in pitch from one note to the next (without re-triggering the note) when the gate time length overlaps the timing of the next note.

For higher settings of this value, the time required to arrive at the next pitch will be longer. If this is set to 0, the target pitch will be reached immediately, but without retriggering; this is useful for simulating legato performance technique on a bass.

This parameter is valid only for the keyboard parts.

The time from when the next note is played until that pitch is reached will synchronize to the tempo of the pattern.

The Glide effect is disabled while the ROLL key is on (lit).

START POINT ...............................................................

0...127

Specifies the point from which the sample assigned to each part will play back. If you turn the knob all the way to the left, the sample will play back from the beginning (i.e., normal playback). If you turn the knob all the way to the right, the sample will play back from the end.

PAN

.......................................................................... L63..R63

 

Specifies the stereo position (pan) of the sound. If the knob is in the

 

center position, the sound will be located in the middle. Turning the

 

knob toward the left moves the sound toward the L side; turning it

 

toward the right moves the sound toward the R side.

LEVEL ..........................................................................

0...127

Adjusts the output level. Turn the knob toward the right to make

the sound louder.

 

AMP EG .........................................................................

,

Switches the type of amp EG. Each press of this key switches between an envelope “” that will decay over the time specified by EG TIME, and a “” type envelope that will turn the sound off after the time specified by EG TIME.

ROLL ......................................................................................

Switches “roll” (repeated strikes) on (lit) or off (dark) for each part. The roll spacing depends on the tempo of the pattern, the Roll Type, and the Swing value. (☞ p.38 “Specifying the Roll Type”)

When Roll is on, holding down a part key will play a roll as long as you continue holding the key.

When Roll is on, holding down a step key (when the Keyboard function is on) will play that key as a roll as long as you continue holding the key.

FX SELECT .........................................................FX1, FX2, FX3

Selects the effect to apply. Press the key repeatedly to cycle through the three available effects.

If FX SEND (effect send) is on, the selected effect will be applied. This setting is ignored for parts assigned to output bus 3/4.

FX SEND .....................................................................

On, Off

Selects whether the effect will be used. This will alternate on (lit) and off (dark) each time you press the key. The effect you selected for FX SELECT is the one that will be applied. This setting is ignored for parts assigned to output bus 3/4.

Note on

Note off

 

 

 

 

 

 

 

 

 

 

 

Note on

Note off

(☞ p.38 “Assigning parts”)

48