Initializing the user data

This operation will erase all patterns and song data. When you initialize the user data, all the patterns, songs, and samples you created will be erased. If you want keep the data you created, save your data on SmartMedia before you initialize.

1.While holding down the SOLO key and WRITE/ RENAME key, turn on the power.2.The display will indicate "ALL Init," and the PLAY/ PAUSE key will blink.

3.To execute the Initialize operation, press the blink- ing PLAY/PAUSE key. To cancel without initializ- ing, press the STOP/CANCEL key.

It will take about 30 seconds for initialization to be completed.

When loading is completed, the ESX-1 will be re- stored to its initial state, and after several seconds the display will indicate pattern number "A.01" and

enter Pattern mode.Never turn off the power while the ESX-1 is beinginitialized.

8. Appendix

Specifications
Number of parts:

16 parts

 

2 keyboard parts, 9 drum parts, 1 drum accent

 

part, 1 stretch part, 1 slice part, 1 audio in part,

 

1 accent part

Sample capacity:

384 (256 monaural, 128 stereo) or a maximum

 

of 285 seconds (monaural)

Sampling frequency: 44.1 kHz
Memory capacity:

256 patterns, 64 songs

Effects:

Three processors x 16 types

Sequences:

Maximum of 128 steps per part.

Motion sequences: Total of 24 freely assignable sequences totaling

Song:

Maximum of 256 patterns per song.

 

Maximum 20,000 events for event recording.

Connectors**:

 

PHONES

 

 

Phone jack: stereo

 

Maximum output level: 16 mW/33-ohms or

 

more / TUBE GAIN = min

 

Output impedance: 33 ohms

OUTPUT (L/MONO, R)

 

Phone jacks: mono x 2

 

Maximum output level: 0 dBu or more / TUBE

 

GAIN = min

 

Output impedance: 220-ohm (110-ohm at

 

MONO)

 

Load impedance: 10 k-ohms or more

INDV.OUT (3, 4)

 

Phone jacks: mono x 2

 

Maximum output level: +7 dBu or more

 

Output impedance: 220-ohm

 

Load impedance: 10 k-ohms or more

INPUT (AUDIO IN)

 

Phone jack: stereo (unbalanced)

 

Input impedance: 10 k-ohms (at LINE) /

 

910-ohm (at MIC)

 

Maximum input level

 

(at LINE): -20dBu/ AUDIO IN LEVEL = max

 

(at MIC): -52 dBu / AUDIO IN LEVEL = max

 

Source impedance: 600 ohms

MIDI (IN, OUT, THRU)

 

5-pin DIN

SmartMediaTM:

4–128 MB, 3V (3.3V)

Vacuum tube:

12AX7/ECC83 x 2

Power supply:

AC9V (included AC/AC power supply)

Power consumption:

23 W

Dimensions:

358 (W) x 256 (D) x 62 (H) mm (including the

 

rubber feet)

Weight:

3.1 kg

**Analog specifications such as output levels are measured at the point where the vacuum tubes have stabilized af- ter power-on. These values may change due to variations in the environmental temperature.

99