113
EFFECT
Pitch/Phase Mod.

Pitch/phase modulation effects

16: St.Chorus (Stereo Chorus)
This effect adds thickness and warmth to the sound by modu-
lating the delay time of the input signal. You can add spread
to the sound by offsetting the phase of the left and right LFOs
from each other.
e: L Dly, e: R Dly
Setting the left and right delay time individually allows you to
control the stereo image.

17: St.HarmnicCho

(Stereo Harmonic Chorus)

This effect applies chorus only to higher frequencies. This can
be used to apply a chorus effect to a bass sound without mak-
ing the sound thinner. You can also use this chorus block with
feedback as a flanger.
e: Hi/Lo Split
This parameter sets the frequency that splits the high and low
range. Only the high range will be sent to the chorus block.
aLFO Wave (LFO Waveform)
Selects LFO Waveform Triangle, Sine
bLFO Phase –180...+180deg
Sets the LFO phase difference between the left and right ☞ Fx:10
c
Freq (LFO Frequency) 0.02...20.00Hz
Sets the LFO speed ☞ Fx:09,
(Source)
Selects the modulation source of LFO speed Off...Tempo
(Amount) –20.00...+20.00Hz
Sets the modulation amount of LFO speed
d
BPM/MIDI Sync Off, On
Switches between using the frequency of the LFO speed and using
the tempo and notes ☞ Fx:09,
BPM
Selects MIDI Clock and assigns tempo MIDI, 40...240
☞ Fx:09
Base (Base Note)                  
Selects the type of notes that specify the LFO speed ☞ Fx:09
Times 1...16
Sets the number of notes that specify the LFO speed ☞ Fx:09
e
L Dly (L Pre Delay)
Sets the delay time for the left channel 0.0...50.0ms
☞
R Dly (R Pre Delay)
Sets the delay time for the right channel 0.0...50.0ms
☞
f
Depth
Sets the depth of LFO modulation 0...100
(Source) Off...Tempo
Selects the modulation source of the LFO modulation depth
(Amount) –100...+100
Sets the modulation amount of the LFO modulation depth
gPre EQ Trim
Sets the EQ input level 0...100
h
LoEQ (Pre Low EQ Gain)
Sets the gain of Low EQ –15.0...+15.0dB
HiEQ (Pre High EQ Gain)
Sets the gain of High EQ –15.0...+15.0dB
i
W/D (Wet/Dly) –Wet...–1:99, Dry, 1:99...Wet
Sets the balance between the effect and dry sounds
☞ Fx:10,
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance –100...+100
Chorus
Chorus
Left
Right
LFO Phase
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
EQ Trim
EQ Trim
LEQ HEQ
LEQ HEQ
LFO: Tri / Sine
aLFO Wave (LFO Waveform)
Selects LFO Waveform Triangle, Sine
bLFO Phase –180...+180deg
Sets the LFO phase difference between the left and right ☞ Fx:10
c
Freq (LFO Frequency) 0.02...20.00Hz
Sets the LFO speed ☞ Fx:09,
(Source)
Selects the modulation source of LFO speed Off...Tempo
(Amount) –20.00...+20.00Hz
Sets the modulation amount of LFO speed
d
BPM/MIDI Sync Off, On
Switches between using the frequency of the LFO speed and using
the tempo and notes ☞ Fx:09,
BPM
Selects MIDI Clock and assigns tempo MIDI, 40...240
☞ Fx:09
Base (Base Note)                 ��� 
Selects the type of notes that specify the LFO speed ☞ Fx:09
Times 1...16
Sets the number of notes that specify the LFO speed ☞ Fx:09
e
Dly (Delay Time)
Sets the delay time from the original sound 0.0...50.0ms
Hi/Lo Split (High/Low Split Point) 1...100
Sets the frequency split point between the high and low range ☞
f
Depth
Sets the depth of LFO modulation 0...100
(Source) Off...Tempo
Selects the modulation source of the LFO modulation depth
(Amount) –100...+100
Sets the modulation amount of the LFO modulation depth
g
Feedback
Sets the feed back amount of the chorus block –100...+100
☞
HiDamp (High Damp) 0...100%
Sets the high range damping amount of the chorus block
h
Lo Level (Low Level)
Sets the low range output level 0...100
Hi Level (High Level)
Sets the high range (chorus) output level 0...100
i
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance –100...+100
Left
Right
Feedback
LFO Phase
LFO: Tri / Sine
Wet / Dry
Wet / Dry
High Damp
Stereo In - Stereo Out
Low Level
Low Level
High Level
High Level
High/Low Split Point High Damp
Chorus/Flanger
Chorus/Flanger