146
83: Wah–AmpSim

(Wah/Auto Wah – Amp Simulation)

This effect combines a mono-type wah and an amp simula-

tion. You can change the order of the effect connection.

84: Deci–AmpSim

(Decimator – Amp Simulation)

This effect combines a mono-type decimator and an amp sim-

ulation. You can change the order of the effect connection.

85: Deci–Comp

(Decimator – Compressor)

This effect combines a mono-type decimator and a compres-

sor. You can change the order of the effect connection.

a
[WAH] Freq Btm (Frequency Bottom)
Sets the lower limit of the wah center frequency 0...100
☞ Fx:09
Top (Frequency Top)
Sets the upper limit of the wah center frequency 0...100
☞ Fx:09
b
Swp Mode (Sweep Mode) Auto, Dmod, LFO
Selects the control from auto-wah, modulation source, and LFO
☞ Fx:09,
Src (Source) Off...Tempo
Selects the modulation source for the wah when Swp Mode=Dmod
clfoF (LFO Frequency)
Sets the LFO speed 0.02...20.00Hz
d
Resonance
Sets the resonance amount 0...100
LPF (Low Pass Filter)
Switches the wah low pass filter on and off Off, On
e[AMP] Amplifier Type
Selects the type of guitar amplifier SS, EL84, 6L6
f[Routing] WAH → AMP, AMP → WAH
Switches the order of the wah and amp simulation connection
g
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance –100...+100
a[DECI] Pre LPF Off, On
Turn the harmonic noise caused by lowered sampling on and off
☞ Fx:14
bHigh Damp
Sets the ratio of high-range damping 0...100%
cSampling Freq (Sampling Frequency)
Sets the sampling frequency 1.00k...48.00kHz
dResolution
Sets the data bit length 4...24
☞ Fx:14
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
RoutingAmp Simulation
Amp Simulation Filter
Wah/Auto Wah
Wah
D
-mod
Envelope
Sweep Mode
D-mod
Auto
LFO
LFO
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Decimator Routing
Amp Simulation
Amp Simulation Filter
Pre LPF High Damp
Output Level
Decimator
Resolution
eLevel (Output Level)
Sets the decimator output level 0...100
☞ Fx:14
f[AMP] Amplifier Type
Selects the type of guitar amplifier SS, EL84, 6L6
g[Routing] DECI→AMP, AMP→DECI
Switches the order of the wah and amp simulation connection
h
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance –100...+100
a
[DECI] Pre LPF Off, On
Turn the harmonic noise caused by lowered sampling on and off
☞ Fx:14
High Damp
Sets the ratio of high-range damping 0...100%
bSampling Freq (Sampling Frequency)
Sets the sampling frequency 1.00k...48.00kHz
cResolution
Sets the data bit length 4...24
☞ Fx:14
dLevel (Output Level)
Sets the decimator output level 0...100
☞ Fx:14
e[CMP] Sensitivity
Sets the sensitivity 1...100
☞ Fx:02
f
Attack
Sets the attack level 1...100
☞ Fx:02
Level (Output Level)
Sets the compressor output level 0...100
☞ Fx:02
g[Routing] DECI→CMP, CMP→DECI
Switches the order of the decimator and compressor connection
h
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance –100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Decimator Routing
Pre LPF High Damp
Output Level
Decimator
Resolution
Compressor
Comp
Output Level
Envelope - Control