Mounting the Device Housing | Kramer Electronics RC-81R manual

Installing the RC-8IR Universal Room Controller

5.2Mounting the Device Housing

The device housing is mounted to the wall via the two housing mounting screws holes, as illustrated in Figure 6:

Figure 6: Mounting the Device Housing

5.3Mounting the RC-8IR Faceplate

1.Place the faceplate on the RC-8IRso that the two screw mounting holes are aligned (see Figure 7).

2.Insert the two mounting screws and tighten with a screwdriver.

Figure 7: Mounting the Faceplate

7

Image 10

Kramer Electronics RC-81R user manual Mounting the Device Housing, Mounting the RC-8IR Faceplate

Contents

Model Contents Figures Tables Introduction Getting Started Overview Up to five machines with unique IP addresses RC-8IR Front Panel Features Your Universal Room Controller Define the RC-8IRright side panel Installing the RC-8IR Universal Room Controller Installing the RC-8IR Universal Room Controller Setting the Labels and Button Caps Button Cap Orientation Mounting the Device Housing Mounting the RC-8IR Faceplate Using the RC-8IR Universal Room Controller Example of a Typical RC-8IR Configuration Example of a Typical RC-8IR Setup in the Lecture Auditorium Commands Configuration Operating the RC-8IR An Example of Operating the RC-8IR Shows an operating example Locking the Front Panel Using the Macro ButtonsUsing the Internal Web Turning the Light of the Backlit Buttons On and Off Flash Memory Upgrade Downloading from the Internet Connecting the PC to the RS-232 Port Upgrading Firmware Technical Specifications Installing the Web Applet Limited Warranty 2900-REV